Audio Fix / setup help
Focusrite Scarlett Solo 4th Gen: remove a known duplicate software monitoring path
Focusrite Scarlett Solo 4th Gen: remove a known duplicate software monitoring path. Check prerequisites and the actual response before reporting an outcome.
Manufacturer-documented Reviewed 2026-11-09 · Revision 1
Follow these checks in Audio Fix →When this guide applies
Live input already audible through hardware Direct Monitor and also through DAW monitoring.
Connection scope: USB audio. Symptom: Sound and picture are out of sync.
This is a documented check, not a diagnosis of your equipment. The model name does not confirm the selected input, mode, software or connected partner.
If your exact model or a required setting is unknown, use the “I don’t know” branch below. Do not apply a similarly named model’s instructions.
Checks and possible outcomes
Start at step-0. Follow the link that matches what you actually observe. Alternative branches are not a single sequence of actions.
step-0
Is the intended live input already audible through Direct Monitor?
Do not remove the only available listening path.
Look for: Confirm the actual prerequisite or observation. Unknown stops safely.
- If Yes / check completed → Is the same input also being monitored through the DAW?
- If No / cannot confirm → Keep these observations for official support
- If I do not know / cannot check → A required fact is unknown
- Manufacturer-documented Focusrite Scarlett Solo 4th Gen official user guide ↗PDF pages 14 — Direct monitoring is white when off and green when on; it hears live inputs without software effects.Exact model/generation named in this manual; external controls and documented host paths only. · Source checked 2026-11-09
step-1
Is the same input also being monitored through the DAW?
An unrelated playback delay is outside this doubled-input flow.
Look for: Confirm the actual prerequisite or observation. Unknown stops safely.
- If Yes / check completed → May software monitoring be disabled on that track?
- If No / cannot confirm → Keep these observations for official support
- If I do not know / cannot check → A required fact is unknown
- Manufacturer-documented Focusrite Scarlett Solo 4th Gen official user guide ↗PDF pages 14 — Direct monitoring is white when off and green when on; it hears live inputs without software effects.Exact model/generation named in this manual; external controls and documented host paths only. · Source checked 2026-11-09
step-2
May software monitoring be disabled on that track?
This changes monitoring rather than hardware input recording gain.
Look for: Confirm the actual prerequisite or observation. Unknown stops safely.
- If Yes / check completed → Mute that recording track monitoring in the DAW
- If No / cannot confirm → Keep these observations for official support
- If I do not know / cannot check → A required fact is unknown
- Manufacturer-documented Focusrite Scarlett Solo 4th Gen official user guide ↗PDF pages 14 — Direct monitoring is white when off and green when on; it hears live inputs without software effects.Exact model/generation named in this manual; external controls and documented host paths only. · Source checked 2026-11-09
step-3
Mute that recording track monitoring in the DAW
Keep the established hardware Direct Monitor path. Its clean signal does not include software effects.
Look for: Perform only the stated operation, then confirm whether it could be completed.
- If Yes / check completed → Does the unwanted doubled or delayed second input disappear?
- If No / cannot confirm → Keep these observations for official support
- If I do not know / cannot check → A required fact is unknown
- Manufacturer-documented Focusrite Scarlett Solo 4th Gen official user guide ↗PDF pages 14 — Direct monitoring is white when off and green when on; it hears live inputs without software effects.Exact model/generation named in this manual; external controls and documented host paths only. · Source checked 2026-11-09
step-4
Does the unwanted doubled or delayed second input disappear?
This is an observation rather than a measured round-trip latency result.
Look for: Confirm the actual prerequisite or observation. Unknown stops safely.
- If Yes / check completed → Checks completed — report what happened
- If No / cannot confirm → Keep these observations for official support
- If I do not know / cannot check → A required fact is unknown
- Manufacturer-documented Focusrite Scarlett Solo 4th Gen official user guide ↗PDF pages 14 — Direct monitoring is white when off and green when on; it hears live inputs without software effects.Exact model/generation named in this manual; external controls and documented host paths only. · Source checked 2026-11-09
Possible result
Checks completed — report what happened
Completion is not an automatic solved result. Report solved, partly helped, did not help or could not follow based on your actual observation. No Audio Review physical test is claimed.
steps completed
Reaching this result does not mean the issue is solved. Only your own feedback can report improvement.
Possible result
Keep these observations for official support
A required prerequisite or response was not confirmed. Stop this sequence and use the exact model and partner documentation. Do not escalate to a factory reset, firmware installation, internal repair or unsafe wiring change.
next support
Reaching this result does not mean the issue is solved. Only your own feedback can report improvement.
Possible result
A required fact is unknown
Confirm the exact model, connection, partner capability and current control state before continuing. Do not guess settings or operate an updating product.
insufficient data
Reaching this result does not mean the issue is solved. Only your own feedback can report improvement.