Audio Fix / setup help
Arcam A25: Check unwanted standby after an idle period
Arcam A25 — Check unwanted standby after an idle period. Follow the exact documented route and keep the actual result.
Manufacturer-documented Reviewed 2026-11-09 · Revision 1
Follow these checks in Audio Fix →When this guide applies
Exact Arcam A25. Known idle timeout only; unexpected shutdown during playback is outside this procedure. Only normal external user controls; no mains modification, chassis opening, reset or firmware installation.
Connection scope: Device controls / power only. Symptom: Power-on or automatic standby isn’t working.
This is a documented check, not a diagnosis of your equipment. The model name does not confirm the selected input, mode, software or connected partner.
If your exact model or a required setting is unknown, use the “I don’t know” branch below. Do not apply a similarly named model’s instructions.
Checks and possible outcomes
Start at scope. Follow the link that matches what you actually observe. Alternative branches are not a single sequence of actions.
scope
Confirm the exact setup
Does standby occur only after the documented idle period, and do you accept higher energy use if automatic standby is disabled?
Look for: Choose only a detail you can confirm.
- If Yes, confirmed → Open Eco Timer
- If No → Keep the actual observation for support
- If I do not know / cannot check → Confirm the unknown detail first
- Manufacturer-documented ARCAM A5/A15/A25 English Owner’s Manual ↗Standby, PDF p9; Eco Timer, PDF p10; energy note, PDF p4 — Automatic standby follows 20 minutes without audio or interaction. Eco Timer Off disables it and increases energy consumption.Original ARCAM A25; not the later + model. · Source checked 2026-11-09
a1
Open Eco Timer
Open Settings and select Eco Timer.
Look for: Perform this one check and observe the actual response.
- If I completed this step → Disable the unwanted idle timer
- If I cannot complete this step → Keep the actual observation for support
- If I do not know / cannot check → Confirm the unknown detail first
- Manufacturer-documented ARCAM A5/A15/A25 English Owner’s Manual ↗Standby, PDF p9; Eco Timer, PDF p10; energy note, PDF p4 — Automatic standby follows 20 minutes without audio or interaction. Eco Timer Off disables it and increases energy consumption.Original ARCAM A25; not the later + model. · Source checked 2026-11-09
a2
Disable the unwanted idle timer
If Eco Timer is enabled, select Off. Do not treat this as a fix for protection shutdown or power loss during playback.
Look for: Perform this one check and observe the actual response.
- If I completed this step → Check the actual result
- If I cannot complete this step → Keep the actual observation for support
- If I do not know / cannot check → Confirm the unknown detail first
- Manufacturer-documented ARCAM A5/A15/A25 English Owner’s Manual ↗Standby, PDF p9; Eco Timer, PDF p10; energy note, PDF p4 — Automatic standby follows 20 minutes without audio or interaction. Eco Timer Off disables it and increases energy consumption.Original ARCAM A25; not the later + model. · Source checked 2026-11-09
result
Check the actual result
After the same idle conditions, does the unit now remain available as intended?
Look for: Choose only a detail you can confirm.
- If Yes, confirmed → Checks completed — keep the observed result
- If No → Keep the actual observation for support
- If I do not know / cannot check → Confirm the unknown detail first
- Manufacturer-documented ARCAM A5/A15/A25 English Owner’s Manual ↗Standby, PDF p9; Eco Timer, PDF p10; energy note, PDF p4 — Automatic standby follows 20 minutes without audio or interaction. Eco Timer Off disables it and increases energy consumption.Original ARCAM A25; not the later + model. · Source checked 2026-11-09
Possible result
Confirm the unknown detail first
Do not infer a source setting, installed cartridge, connector role, software state or partner capability. Obtain the exact documentation before continuing.
insufficient data
Reaching this result does not mean the issue is solved. Only your own feedback can report improvement.
Possible result
Keep the actual observation for support
Record the exact model, source, input and last observed response. These checks do not diagnose a failed component. No reset, service work or blind update is prescribed.
next support
Reaching this result does not mean the issue is solved. Only your own feedback can report improvement.
Possible result
Checks completed — keep the observed result
This records the observation in this particular setup, not a guaranteed cure, physical Audio Review test or measurement.
steps completed
Reaching this result does not mean the issue is solved. Only your own feedback can report improvement.